LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2005 >> Sequoia Limited, 4WD >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Electrical System Troubleshooting >> Problem Symptoms Tables >> Power Window Control System

Power Window Control System

This system uses the multiplex communication system, so check diagnosis system of the multiplex communication system before you proceed with troubleshooting.

PROBLEM SYMPTOMS TABLE - POWER WINDOW CONTROL SYSTEM

Symptom Suspect Area
All the power windows do not operate. (Power door lock system is normal.)
  1. POWER MAIN Relay
  2. Driver Door ECU (Power Window Master Switch)
  3. Body ECU
  4. Wire Harness
Only the driver's window does not operate.
  1. Power Window Motor
  2. Power Window Pulse Sensor Circuit
  3. Power Window Limit Switch Circuit
  4. Driver Door ECU (Power Window Master Switch)
"Window lock function" does not operate. Driver Door ECU (Power Window Master Switch)
Only the rear LH window does not operate.
  1. Power Window Motor
  2. Power Window Switch
  3. Body ECU
Only the rear RH window does not operate.
  1. Power Window Motor
  2. Power Window Switch
  3. Body ECU
Only the front passenger's window does not operate.
  1. Power Window Motor
  2. Power Window Pulse Sensor Circuit
  3. Power Window Limit Switch Circuit
  4. Passenger Door ECU
The Key related power window operations do not operate with driver side door key cylinder.
(Master switch operation is normal.)
  1. Door Key Lock and Unlock Switch Circuit
  2. Driver Door ECU (Power Window Master Switch)
" Auto up " or" Auto down " does not operate. (1)
  1. Power Window Pulse Sensor Circuit
  2. Power Window Limit Switch Circuit
  3. Driver Door ECU (Power Window Master Switch)
(1) "Auto up" or "Auto down" may not function when the manual switch is pressed and held for 2 sec. or more with the window glass fully open or closed. In this case, by performing a sequence of the window glass operations (full open, fully close and then half open), the function can be restored. If not, replace the driver door ECU or passenger door ECU.