Front Lower Ball Joint: Installation
- INSTALL LOWER BALL JOINT
- Install the lower ball joint with the nut.
Torque: 133 N.m (1,360 kgf.cm, 98 ft.lbf)
- Install a new cotter pin.
If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.
- Install the lower ball joint with the nut.
- INSTALL STEERING KNUCKLE WITH AXLE HUB (See INSTALLATION )
- CHECK ABS SPEED SENSOR SIGNAL (See DTC DTC C0200/31 - C1239/39 )
- CHECK FRONT WHEEL ALIGNMENT (See FRONT WHEEL ALIGNMENT )