Inspection Procedure
- PERFORM ACTIVE TEST BY HAND HELD TESTER
- Connect the hand-held tester to the DLC3.
- Check the CRUISE main indicator light by using ACTIVE TEST.
COMBINATION METER ASSY:
ACTIVE TEST DATA LIST (COMBINATION METER ASSY)Item Vehicle Condition/Test Details Diagnostic Note CRUISE INDIC "CRUISE" Indicator is ON/OFF - - OK: Indicator light comes on/goes off.
- NG: GO TO COMBINATION METER SYSTEM (SEE HOW TO PROCEED WITH TROUBLESHOOTING )
- OK: Go To Next Step
- READ VALUE OF HAND HELD TESTER
- Connect the hand-held tester to the DLC3.
- Turn the ignition switch to the ON position and turn the hand-held tester main switch on.
- Select the item below in the "DATA LIST", and read the display on the hand-held tester.
CC (ECM):
DATA LIST (CC (ECM))Item Measurement Item/Display (Range) Normal Condition Diagnostic Note CCS INDICATOR M Cruise indicator signal (Main CPU)/ON or OFF ON: CRUISE main indicator light is on OFF: CRUISE main indicator light is off - CCS INDICATOR S Cruise indicator signal (Sub CPU)/ON or OFF ON: CRUISE main indicator light is on OFF: CRUISE main indicator light is off - - OK: When cruise control main switch operation is performed, the standard values will be above.
- NG: REPLACE ECM (SEE ECM (3MZ-FE) )
- OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (SEE PROBLEM SYMPTOMS TABLE )