Torque Specifications
AUTOMATIC TRANSAXLE TORQUE SPECIFICATIONS
| Part tightened | N.m | kgf.cm | ft.lbf | |
|---|---|---|---|---|
| Vehicle speed sensor at Transaxle | 7.0 | 71 | 5 | |
| Direct clutch speed sensor at Transaxle | 5.4 | 55 | 48 in.lbf | |
| Transaxle control cable at Control shaft | 15 | 150 | 11 | |
| Control shaft at Park/neutral position switch | 13 | 130 | 9 | |
| Park/neutral position switch at Transaxle | Bolt | 5.4 | 55 | 48 in.lbf |
| Nut | 6.9 | 70 | 61 in.lbf | |
| Solenoid valve at Valve body | 12 mm bolt: | 11 | 110 | 8 |
| 45 mm bolt: | 11 | 110 | 8 | |
| Valve body at Transaxle | 11 | 110 | 8 | |
| ATF temperature sensor at Valve body | 11 | 110 | 8 | |
| Oil strainer at Valve body | 11 | 110 | 8 | |
| Oil pan at Transaxle | 7.8 | 80 | 69 in.lbf | |
| Drain plug at Oil pan | 49 | 500 | 36 | |
| Floor shift assembly at Body | 12 | 120 | 9 | |
| Floor shift assembly at Transaxle control cable | 12 | 120 | 9 | |
| Air cleaner bracket at Transaxle | 19 | 195 | 14 | |
| Starter at Engine | 39 | 400 | 29 | |
| Transaxle at Engine | 29.5 | 300 | 22 | |
| Engine hanger at Engine | 40 | 400 | 29 | |
| Steering wheel at column shaft | 34 | 350 | 25 | |
| Tie rod end at Axle carrier | 49 | 500 | 36 | |
| Torque converter clutch at Drive plate | 27 | 275 | 20 | |
| Lower suspension arm at Axle carrier | 98 | 1,000 | 72 | |
| Drive shaft lock nut | 216 | 2,200 | 159 | |
| Hood at Hood hinge | 11 | 115 | 8 | |
| LH engine mounting at Transaxle | 49 | 500 | 36 | |
| Drive plate at Crank shaft | 88 | 900 | 65 | |
| PS pipe clamp at front suspension member | 7.8 | 80 | 69 in.lbf | |
| Rear engine mounting bracket at Front suspension member | 80 | 810 | 59 | |
| Front suspension member at Body | Bolt A: | 116 | 1,185 | 86 |
| (MS: See
REMOVAL
) (PS: See REMOVAL ) |
Bolt B: | 70 | 715 | 52 |
| Wiper arm at Wiper link assembly | 21 | 214 | 15 | |
| Wiper arm assembly at Body | 5.5 | 55 | 49 in.lbf | |
| Outer front cowl top panel at Body | 5.0 | 50 | 43 in.lbf | |
| No.3 intermediate shaft assembly at Steering gear assembly | 47 | 480 | 35 | |
| PS only: Pressure feed and return tubes at Steering gear assembly |
37 (44) | 375 (450) | 27 (33) | |
(): For use without SST