Torque Specifications
MANUAL TRANSAXLE TORQUE SPECIFICATIONS
| Part tightened | N.m | kgf.cm | ft.lbf |
|---|---|---|---|
| No.2 cylinder head cover | 7.0 | 71 | 62 in.lbf |
| Clutch line bracket set bolt | 4.9 | 50 | 43 in.lbf |
| Clutch release cylinder at Transaxle | 12 | 120 | 9 |
| Transaxle at Engine | 33 | 340 | 25 |
| Starter at Transaxle | 39 | 400 | 29 |
| No. 1 engine hanger | 40 | 400 | 29 |
| Engine left mounting bracket at Engine left mounting insulator | 49 | 490 | 35 |
| Engine rear mounting insulator at Engine rear mounting bracket | 64 | 650 | 47 |
| Engine rear mounting bracket at Transaxle | 49 | 500 | 36 |
| Shift lever assembly at Body | 12 | 120 | 9 |
| Shift and select control cable at Body | 4.9 | 50 | 43 in.lbf |
| Clutch release fork support | 37 | 375 | 27 |
| Filler and drain plugs | 39 | 400 | 29 |
| Vehicle speed sensor | 11 | 115 | 8 |
| Back-up light switch | 40 | 410 | 30 |
| Control lever housing support bracket at Transaxle case | 11 | 115 | 8 |
| Selecting bellcrank assembly at Transmission case | 25 | 250 | 18 |
| Transmission case at Transmission case cover | 18 | 185 | 13 |
| Shift and select lever shaft assembly lock bolt | 29 | 300 | 22 |
| Shift and select lever assembly | 20 | 200 | 14 |
| Output shaft lock nut | 118 | 1,200 | 87 |
| Shift fork and shift head at Shift fork shaft | 16 | 160 | 12 |
| Rear bearing retainer | 27 | 280 | 20 |
| Reverse idler gear shaft lock bolt | 29 | 300 | 22 |
| Straight screw plug (Shift fork shaft) | 25 | 250 | 18 |
| Lock ball assembly | 39 | 400 | 29 |
| Transmission case at Transaxle case | 29 | 300 | 22 |
| Oil receiver pipe at Transmission case | 17 | 175 | 13 |
| Reverse shift arm bracket | 17 | 175 | 13 |
| Output shaft front bearing lock plate set bolt | 11 | 115 | 8 |
| Transaxle case receiver at Transaxle case | 11 | 115 | 8 |
| Straight screw plug (Reverse restrict pin) | 13 | 130 | 9 |
| Ring gear at Differential case | 124 | 1,260 | 91 |