Rear Wheel Alignment: Inspection

INSPECT TIRE (See WHEEL AND TIRE SYSTEM )
MEASURE VEHICLE HEIGHT (See FRONT WHEEL ALIGNMENT )
NOTE: Before inspecting wheel alignment, adjust the vehicle height to the specified value.

Fig 1: Inspecting Toe-In
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT TOE-IN
USA, Canada:

Fig 2: Toe-In Specification (USA, Canada)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Mexico:

Fig 3: Toe-In Specification (Mexico)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:
- Measure "C - D" only when "A + B" cannot be measured.
- If toe-in is not within the specified range, inspect the suspension parts for damage and/or wear, and replace them if necessary.
INSPECT CAMBER
1. Install the camber-caster-kingpin gauge or set the vehicle on the wheel alignment tester.
2. Inspect the camber.
USA, Canada:

Fig 4: Camber Specification (USA, Canada)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Mexico:

Fig 5: Camber Specification (Mexico)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Camber is not adjustable. If the measurement is not within the specified range, inspect the suspension parts for damage and/or wear, and replace them if necessary.