LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2005 >> Avalon XLS >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Smart Key System (Keyless Entry) >> Luggage Compartment Open Switch Circuit >> Inspection Procedure

Inspection Procedure

  1. INSPECT LUGGAGE COMPARTMENT OPEN SWITCH 
    1. Disconnect the switch connector.
    2. Measure the resistance according to the value (s) in the table below.

      Standard: 

      LUGGAGE COMPARTMENT OPEN SWITCH RESISTANCE

      Tester Connection Condition Specified Condition
      L23-1 - L23-2 Luggage compartment open switch not pushed --> Pushed 10 kΩ or higher --> Below 1 Ω
      Fig 1: Inspecting Luggage Compartment Open Switch
      G02977187Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. NG : REPLACE LUGGAGE COMPARTMENT OPEN SWITCH 
    2. OK : Go to next step. 
  2. CHECK WIRE HARNESS (CERTIFICATION ECU - LUGGAGE COMPARTMENT OPEN SWITCH) 
    1. Reconnect the switch connector.
    2. Disconnect the D39 ECU connector.
    3. Measure the resistance according to the value (s) in the table below.

      Standard: 

      CERTIFICATION ECU - LUGGAGE COMPARTMENT OPEN SWITCH RESISTANCE

      Tester Connection Condition Specified Condition
      TSW5 (D39-7) - Body ground Luggage compartment open switch not pushed --> Pushed 10 kΩ or higher --> Below 1 Ω
      Fig 2: Disconnecting D39 Certification ECU Connector
      G02977188Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. NG : REPAIR OR REPLACE WIRE HARNESS OR CONNECTOR 
    2. OK : PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE  
scientia non olet · About LEMON Manuals