Inspection Procedure
- Check ODMS circuit.
When using the hand-held tester:
PREPARATION:
- Connect the hand-held tester to the DLC3.
- Turn the ignition switch ON.
CHECK:
Read the OVERDRV CUT SW2 signal on the hand-held tester.
- OK:
O/D MAIN SWITCH DISPLAYO/D Main Switch Display Pressed when O/D ON OFF Pressed when O/D OFF ON When not using the hand-held tester:
PREPARATION:
- Disconnect the E4 ECM connector (5VZ-FE).
- Disconnect the E3 ECM connector (2UZ-FE).
CHECK:
Measure the resistance between the terminal ODMS of the ECM connector and the body ground.
- OK:
O/D MAIN SWITCH DISPLAYO/D Main Switch Specified Condition Pressed when O/D ON Below 1 Ω Pressed when O/D OFF 10 kΩ or higher - OK: Check and replace ECM (see HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE ).
- NG: Go To Next Step
- Check O/D main switch.
PREPARATION:
Disconnect the O/D main switch connector.
CHECK:
Measure the resistance between the terminal 1 and 3 of the O/D main switch connector.
- Standard:
O/D MAIN SWITCH SPECIFIC CONDITIONO/D Main Switch Specified Condition Pressed when ON position Below 1 Ω Pressed when OFF position 10 kΩ or higher OK:
Standard
- NG: Replace O/D main switch.
- OK: Repair or replace harness and connector between ECM and O/D main switch.