Inspection Procedure
Troubleshooting in accordance with the chart below for each trouble symptom.
INSPECTION PROCEDURE
| Item | Go To |
|---|---|
| ABS Warning Light Does Not Light Up | Go To Step 1 |
| ABS Warning Light Remains On | Go To Step 2 |
- Check ABS warning light.
See COMBINATION METER TROUBLESHOOTING
- NG: Repair bulb or combination meter assembly.
- OK: Check for open in harness and connector between GAUGE fuse and skid control ECU (See HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE ).
- Is DTC output.
Check DTC DIAGNOSTIC TROUBLE CODE CHART .
- YES: Repair circuit indicated by the code output.
- NO: Go to next step.
- Check for short in harness and connector between GAUGE fuse and skid control ECU (See HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE ).
- NG: Repair or replace harness or connector.
- OK: Check and repair brake actuator ASSY.