On-Vehicle Repair

DISCONNECT ATF TEMPERATURE SENSOR CONNECTOR
REMOVE ATF TEMPERATURE SENSOR
1. Remove the ATF temperature sensor.
2. Remove the O-ring from the ATF temperature sensor.
INSTALL ATF TEMPERATURE SENSOR
1. Coat a new O-ring with ATF and install it to the ATF temperature sensor.
2. Install the ATF temperature sensor.
Torque: 15 N.m (150 kgf.cm, 11 ft.lbf)
CONNECT ATF TEMPERATURE SENSOR CONNECTOR
NOTE: Be careful not to twist the wire harness.

Fig 1: Removing/Installing ATF Temperature Sensor
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Install the 3 clamps with the 3 bolts.

Fig 2: Installing Clamps Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
FILL ATF AND CHECK FLUID LEVEL (See PRE-CHECK )