Accessory Power Socket: Inspection
- INSPECT MAIN SWITCH CONTINUITY TESTER CONNECTION SPECIFIED CONDITION
Switch Position Tester Connection Specified Condition ON 2 - 3 Continuity OFF 2 - 3 No Continuity Constant 2 - 6 Continuity Illumination Circuit 1 - 4 Continuity If continuity is not as specified, replace the switch.
- INSPECT MAIN INDICATOR LIGHT OPERATION
- Connect the positive (+) lead from the battery to terminal 3 and the negative (-) lead to terminal 2.
- Push the main switch and check that the indicator light comes on.
If operation is not as specified, replace the switch and inspect the circuits connected to other parts.
- INSPECT INVERTER RELAY CONTINUITY TESTER CONNECTION SPECIFIED CONDITION
Condition Tester Connection Specified Condition Constant 1 - 2 Continuity 3 - 5 No Continuity Apply B+ Between Terminals 1 And 2 3 - 5 Continuity If continuity is not as specified, replace the switch.
- INSPECT VOLTAGE INVERTER CIRCUIT
Disconnect the connector from the voltage inverter and inspect the connector on the wire harness side, as shown.
TESTER CONNECTION SPECIFIED CONDITIONSwitch Position Tester Connection Specified Condition ON 1 - 4 Battery Positive Voltage OFF 1 - 4 No Continuity If the circuit is not as specified, inspect the circuits connected to other parts.