Section 906 (Rear Wheel Alignment): Adjustment
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT TIRE (SEE WHEEL AND TIRE SYSTEM )
- MEASURE VEHICLE HEIGHT (SEE
ADJUSTMENT
) NOTE: Before inspecting wheel alignment, adjust the vehicle height to the specified value.
- INSPECT TOE-IN TOE-IN REFERENCE
Toe-in (total) A + B: 0° 24' +/- 12' (0.4° +/- 0.2°)
C - D: 4 +/- 2 mm (0.16 +/- 0.08 in.)HINT:
- Measure "C - D" only when "A + B" cannot be measured.
- If toe-in is not within the specified range, inspect the suspension parts and replace them if necessary.
- ADJUST TOE-IN
- Measure the lengths of the right and left No. 2 lower suspension arms.
No. 2 lower suspension arm length difference: 1.5 mm (0.06 in.) or less
If the left-right difference is larger than 1.5 mm (0.06 in.), adjust it by following the procedures below.
- Loosen the 2 lock nuts.
- Turn the right and left adjusting tubes by an equal amount to adjust toe-in.
HINT:
- Try to adjust toe-in to the center value.
- One turn of each adjusting tube will adjust toe-in by approximately 1.2° (1° 12', 10.8 mm, 0.425 in.).
- Torque the 2 lock nuts.
Torque: 56 N.m (570 kgf.cm, 41 ft.lbf)
- Measure the lengths of the right and left No. 2 lower suspension arms.
- INSPECT CAMBER
Sport pack:
SPORT PACK CAMBER REFERENCE2AZ-FE 3MZ-FE Camber Right-left error -1°21' +/- 45' (-1.35° +/- 0.75°) 45' (0.75°) or less -1 ° 23' +/- 45' (-1.38° +/- 0.75°) 45' (0.75°) or less Except sport pack:
EXCEPT SPORT PACK CAMBER REFERENCE2AZ-FE 3MZ-FE Camber Right-left error -1°21' +/- 45' (-1.35° +/- 0.75°) 45' (0.75°) or less -1° 22' +/- 45' (-1.37° +/- 0.75°) 45' (0.75°) or less HINT:
Camber is not adjustable. If the measurement is not within the specification, inspect the suspension parts for damage and/or wear, and replace them if necessary.