LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Matrix Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 974 (Seat System) >> Front Seat >> Installation

Front Seat: Installation

WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place front seat into vehicle.
  2. Connect wire connectors under seat (Fig 1 ).
    3. Fig 1: Removing Seat Wire Connectors
    G03571792Courtesy of DAIMLERCHRYSLER CORP.
  3. Place front seat studs into mounting holes.
  4. Raise and support vehicle.
  5. Install four nuts attaching seat to floor pan (Figure ).
  6. Tighten nuts to 68 N.m (50 ft. lbs.) torque.
  7. For right side front seat, install muffler to body heat shield. (Refer to HEAT SHIELDS ).
  8. For left side front seat, install vapor canister. (Refer to VAPOR CANISTER ).
  9. Remove vehicle supports and lower vehicle.
  10. Install front seat headrest. (Refer to INSTALLATION  ).
  11. Connect battery negative cable.
scientia non olet · About LEMON Manuals