LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Matrix Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 794 (Automatic Transmission) >> Parking Lock Pawl >> On-Vehicle Repair

On-Vehicle Repair

WARNING: This page is about a different car, the 2004 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE NO. 1 AND NO. 2 ENGINE UNDER COVERS 
  2. REMOVE LH FRONT FLOOR CENTER COVER 
  3. REMOVE NO. 1 REAR FLOOR BOARD 
  4. REMOVE VALVE BODY (See  VALVE BODY ASSEMBLY  ) 
  5. REMOVE PARKING LOCK PAWL BRACKET 

    Remove the 3 bolts and parking lock pawl bracket.

    Fig 1: Removing Parking Lock Pawl Bracket
    G00894494Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE SPRING FROM PARKING LOCK PAWL SHAFT 
    7. Fig 2: Removing Spring From Parking Lock Pawl Shaft
    G00894495Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE PARKING LOCK PAWL SHAFT AND PARKING LOCK PAWL 
  8. INSTALL PARKING LOCK PAWL AND PARKING LOCK PAWL SHAFT 
  9. INSTALL SPIRING TO PARKING LOCK PAWL SHAFT 
  10. INSTALL PARKING LOCK PAWL BRACKET 

    Install the parking lock pawl bracket with the 3 bolts.

    1. Torque: 7.4 N.m (75 kgf.cm, 65 in.lbf) 

    HINT:

    • Push the lock rod fully forward.
    • Check that the parking lock pawl operates smoothly.
  11. INSTALL VALVE BODY (See  VALVE BODY ASSEMBLY  ) 
  12. INSTALL NO. 1 REAR FLOOR BOARD 
  13. INSTALL LH FRONT FLOOR CENTER COVER 
  14. INSTALL NO. 1 AND NO. 2 ENGINE UNDER COVERS 
scientia non olet · About LEMON Manuals