LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Matrix Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 791 (Ignition) >> Crankshaft Position Sensor >> Removal

Crankshaft Position Sensor: Removal

WARNING: This page is about a different car, the 2004 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE GENERATOR (See  REMOVAL & INSTALLATION  ) 
  2. DISCONNECT CRANKSHAFT POSITION SENSOR CONNECTOR 
    1. Disconnect the sensor connector.
    2. Remove the bolt holding the connector bracket to the water pump.
      Fig 1: Removing Connector Bracket Bolt
      G00892723Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Remove the bolt and sensor.
      1. Torque: 9.0 N.m (90 kgf.cm, 80 in..lbf) 
    2. Remove the connector bracket from the connector.
scientia non olet · About LEMON Manuals