Section 495 (Rear Brake Speed Sensor): Removal

WARNING: This page is about a different car, the 2004 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT SPEED SENSOR CONNECTOR
1. Remove the seat cushion and rear side trim.
2. Disconnect the speed sensor connector.
3. Remove the 3 clamp bolts holding the sensor wire harness to the body and suspension arm.
  Torque:
  
  To body: 5.0 N.m (52 kgf.cm, 41 in.lbf)
  
  To suspension arm: 19 N.m (194 kgf.cm, 14 ft.lbf)
2WD: REMOVE SPEED SENSOR WITH AXLE HUB (See REMOVAL )
4WD: REMOVE SPEED SENSOR
Remove the bolt and speed sensor from the axle carrier.

Torque: 8.0 N.m (82 kgf.cm, 70 in.lbf)

Fig 2: Removing Speed Sensor & Bolt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002