Rear Brake Speed Sensor: Installation

INSTALL NEW ABS SPEED SENSOR
1. Clean the contacting surface of the axle hub and a new ABS speed sensor.
  NOTE: Do not stick any foreign objects to the sensor rotor.
2. Place the ABS speed sensor on the axle hub so that the connector is set at the bottom under the on-vehicle condition.
  
  Fig 1: Identifying ABS Speed Sensor On Axle Hub
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using SST and a press, install a new ABS speed sensor to the axle hub.
  SST 09214-7601 1
  NOTE:
  - Do not tap the speed sensor with a hammer directly.
  - Check that there should be no foreign objects on the speed sensor detection portion.
  - Press in the ABS speed sensor straight and slowly.
INSTALL SPEED SENSOR WITH REAR AXLE HUB (See INSTALLATION )

Fig 2: Installing ABS Speed Sensor To Axle Hub Using SST
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT SPEED SENSOR CONNECTOR
INSTALL REAR WHEEL
Torque: 103 N.m (1,050 kgf.cm, 76 ft.lbf)
CHECK SPEED SENSOR SIGNAL (See PRE-CHECK )