Ignition Switch Continuity Test
Measure resistance between ignition switch connector terminals. See Fig 1. Ensure resistance is within specification. See IGNITION SWITCH RESISTANCE SPECIFICATIONS . If switch resistance does not meet specifications, replace switch assembly.
IGNITION SWITCH RESISTANCE SPECIFICATIONS
| Ohmmeter Connection | Ignition Switch Position | Resistance |
|---|---|---|
| ..... | Lock | 10,000 Ohms Or More |
| 2-3 | Accessory | Less Than 1 Ohm |
| 2-3 | On | Less Than 1 Ohm |
| 2-4 | On | Less Than 1 Ohm |
| 6-7 | On | Less Than 1 Ohm |
| 1-2 | Start | Less Than 1 Ohm |
| 1-4 | Start | Less Than 1 Ohm |
| 6-7 | Start | Less Than 1 Ohm |
| 6-8 | Start | Less Than 1 Ohm |