Ignition Switch Continuity Test
Measure resistance between ignition switch connector terminals. See Fig 1. Ensure resistance is within specification. See IGNITION SWITCH RESISTANCE SPECIFICATIONS table. If switch resistance does not meet specifications, replace switch assembly.
IGNITION SWITCH RESISTANCE SPECIFICATIONS
| Ohmmeter Connection | Ignition Switch Position | Resistance |
|---|---|---|
| ..... | Lock | 10,000 Ohms Or More |
| 2-3 | Accessory | Less Than One Ohm |
| 2-3 | On | Less Than One Ohm |
| 2-4 | On | Less Than One Ohm |
| 6-7 | On | Less Than One Ohm |
| 1-2 | Start | Less Than One Ohm |
| 1-4 | Start | Less Than One Ohm |
| 6-7 | Start | Less Than One Ohm |
| 6-8 | Start | Less Than One Ohm |