Body & Frame: Windows: Windshield: Removal

1. Remove the assist grip.
   1. Using a screwdriver, remove the 2 assist grip plugs.
      NOTE: Tape the screwdriver tip before use.
   2. Remove the 2 screws and assist grip.
2. Remove the front pillar garnish.
3. Use the same manner described above to the other side.

Fig 2: Removing Roof Console Box (W/ Sliding Roof)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 2 screws.
2. Using a screwdriver, remove the roof console box.
   NOTE: Tape the screwdriver tip before use.
3. Disconnect the connectors.

Fig 3: Removing Roof Console Box (W/o Sliding Roof)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 4 screws.
2. Using a screwdriver, remove the roof console box.
   NOTE: Tape the screwdriver tip before use.
3. Disconnect the connectors.

Fig 4: Removing Inner Rear View Mirror (W/O Electro Chromic Inner Rear View Mirror)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the torx screw and inner rear view mirror as shown in the illustration.

Fig 5: Removing Inner Rear View Mirror (W/ Electro Chromic Inner Rear View Mirror)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the mirror cover.
2. Disconnect the connector.
3. Remove the torx screw and inner rear view mirror.

1. Using a screwdriver, remove the 2 caps.
   NOTE: Tape the screwdriver tip before use.
2. Remove the 2 nuts and wiper arms.

1. Remove the hood to cowl top seal.
2. Using a clip remover, remove the 6 clips.
3. Remove the 8 screws and cowl top ventilator louver.

Fig 6: Removing Roof Side Rail Weatherstrip

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using SST, pull off the roof side rail weatherstrip from front end.

SST 09806-30010

Remove the 8 screws and windshield outside mouldings.

Fig 7: Identifying Windshield Outside Upper Moulding

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a knife, cut off the moulding as shown in the illustration.

Fig 8: Removing Windshield Glass

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Push piano wire through between the body and glass from the interior.
2. Tie both wire ends to wooden blocks or similar objects.
   NOTE: Apply protective tape to the outer surface to keep the surface from being scratched.
   NOTE: When separating the glass, be careful not to damage the paint and exterior ornaments. To prevent scratching the safety pad when removing the windshield, place a plastic sheet between the piano wire and the safety pad.
3. Cut the adhesive by pulling the piano wire around it.
Fig 9: Cutting Adhesive
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the glass.
   NOTE: Leave as much of the adhesive on the body as possible when cutting off the glass.