Roof Headlining: Removal
- REMOVE REAR SEATS
- REMOVE REAR FLOOR FINISH PLATE
- REMOVE REAR DOOR SCUFF PLATES
- REMOVE ROOM LIGHT AND COVER
- Using a screwdriver, remove the room light cover.NOTE: Tape the screwdriver tip before use.
- Remove the 2 screws and room light, then disconnect the connector.
- Using a screwdriver, remove the room light cover.
- REMOVE ASSIST GRIPS AND COVERS
- REMOVE FRONT DOOR SCUFF PLATES
- REMOVE SUN VISORS
Remove the 4 screws and 2 sun visors.
- REMOVE ROOF CONSOLE BOX
- Using a screwdriver, remove the roof console cover.NOTE: Tape the screwdriver tip before use.
- Remove the 3 screws and roof console box, then disconnect the connector.
- Using a screwdriver, remove the roof console cover.
- REMOVE DECK SIDE TRIM
- Remove the bolt and rear seat outer belt floor anchor.
- Remove the 5 screws.
- Using a screwdriver, remove the deck side trim.
NOTE: Tape the screwdriver tip before use.
- Employ the same manner described above to the other side.
- LH side:
Disconnect the connector.
- REMOVE ROOF SIDE INNER GARNISHES
- Remove the bolt and rear seat outer belt shoulder anchor.
- Remove the 3 clips.
- Using a screwdriver, remove the roof side inner garnish.
NOTE: Tape the screwdriver tip before use.
- Employ the same manner described above to the other side.
- REMOVE CENTER PILLAR LOWER GARNISHES
- Remove the bolt and front seat outer belt floor anchor.
- Pull the center pillar lower garnish upward to remove it.
- Employ the same manner described above to the other side.
- REMOVE CENTER PILLAR UPPER GARNISHES
- Remove the bolt and front seat outer belt shoulder anchor.
- Using a screwdriver, remove the center pillar upper garnish.
NOTE: Tape the screwdriver tip before use.
- Employ the same manner described above to the other side.
- REMOVE FRONT PILLAR GARNISHES
- Using a screwdriver, remove the front pillar garnish.
NOTE: Tape the screwdriver tip before use.
- Employ the same manner described above to the other side.
- Using a screwdriver, remove the front pillar garnish.
- REMOVE ROOF HEADLINING
- Using a screwdriver, remove the roof headlining trim garnish.
NOTE: Tape the screwdriver tip before use.
- Remove the 2 sun visor holders.
- Remove the 4 room partition net hooks.
- Remove the 4 clips and roof headlining.
- Using a screwdriver, remove the roof headlining trim garnish.