LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2003 >> Matrix XRS, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Controls - On-Vehicle Adjustments - 4-Cylinder >> Idle Speed & Mixture >> CAMRY

Idle Speed & Mixture: CAMRY

  1. Idle speed is controlled by Engine Control Module (ECM) and is not adjustable. Check idle speed with engine at normal operating temperature, transaxle in Neutral, parking brake applied, air cleaner and all air intake hoses installed, all vacuum hoses installed, electronic fuel injection system wiring connectors properly installed, ignition timing properly set, electric cooling fan off, and A/C and all accessories off.
  2. If Toyota hand-held tester is available, go to next step. If Toyota hand-held tester is not available, go to step  5.
  3. Start engine and warm engine to normal operating temperature. Shut engine off. Connect Toyota hand-held tester to data link connector No. 3 at driver's side of instrument panel. See Figure. Hand-held tester is used to read engine RPM. Apply parking brake. Place transaxle in Neutral. Start engine and allow engine to idle while noting idle speed. Ensure idle speed is within specification. See IDLE SPEED SPECIFICATIONS  table. Shut engine off. Remove hand-held tester.
  4. If idle speed is not within specification, check air intake system. If air intake system is okay, check throttle body. See IDLE CONTROL SYSTEMS in SYSTEM & COMPONENT TESTING - 4-CYLINDER article.
  5. Start engine and warm engine to normal operating temperature. Shut engine off. Note location of data link connector No. 3 at driver's side of instrument panel. See Figure.
  6. Using Jumper Wire (SST 09843-18040), connect tachometer lead to terminal No. 9 (TAC) on data link connector No. 3. See Figure.
  7. Apply parking brake. Place transaxle in Neutral. Start engine and allow engine to idle while noting idle speed. Ensure idle speed is within specification. See IDLE SPEED SPECIFICATIONS  table. Shut engine off. Disconnect tachometer.
  8. If idle speed is not within specification, check air intake system. If air intake system is okay, check throttle body. See IDLE CONTROL SYSTEMS in SYSTEM & COMPONENT TESTING - 4-CYLINDER article.
IDLE SPEED SPECIFICATIONS (1)

Application RPM
Camry
A/T 610-710
M/T 650-750
Camry Solara
A/T 600-700
M/T 650-750
Celica
1ZZ-FE
A/T 700-800
M/T 650-750
2ZZ-GE
A/T 700-800
M/T 750-850
Corolla 650-750
ECHO
A/T 650-750
M/T 600-700
Highlander 600-700
Matrix
1ZZ-FE 650-750
2ZZ-GE
A/T 700-800
M/T 750-850
MR2 650-750
Prius (2) 950-1050
RAV4 & Tacoma 650-750
(1) Check with engine at normal operating temperature, transaxle/transmission in Neutral (except Prius, in Park on Prius), parking brake applied, air cleaner and all air intake hoses installed, all vacuum hoses installed, electronic fuel injection system wiring connectors properly installed, ignition timing properly set, electric cooling fan off (if equipped), and A/C and all accessories off.
(2) Read service precautions before proceeding with service procedure. See SERVICE PRECAUTIONS . Check with transit in inspection mode and transaxle in Park.