Inspection Procedure

CHECK RELAY (Marking: STARTER CUT)

Fig 1: Inspecting Starter Cut Relay Terminals Continuity
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Remove the starter cut relay.
2. Inspect the starter cut relay continuity, as shown in the illustration and table.
  Standard:
Fig 2: Starter Cut Relay Terminals Continuity Chart
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. NG: REPLACE RELAY
2. OK: Go To Next Step
CHECK WIRE HARNESS (TVIP ECU <--> BODY GROUND)

Fig 3: Identifying SRLY (21) Connector Of TVIP ECU
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Disconnect the TVIP ECU connector.
2. Turn the ignition switch position to the START.
3. Check the voltage between the terminal of the ECU connector and the body ground, as shown in the illustration and table.
  Standard:
Fig 4: Starter Cut Relay Terminals Specified Condition Chart
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. NG: REPAIR OR REPLACE WIRE HARNESS AND CONNECTOR
2. OK: CHECK AND REPLACE TVIP ECU (See ELECTRONIC CIRCUIT INSPECTION PROCEDURE )