Specifications Index
SEQUOIA SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Shaft/Axle Drive Shaft/ Hub Nut | |||
| Axle Shaft Lock Nut | 173 Ft. lbs. (235 N.m) | ||
| Battery | NA | ||
| Brakes | |||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM | ||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | ON-VEHICLE INSPECTION | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Belt Routing | DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| Service | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 10.7-14.9 psi (.75-1.05 kg/cm2
) (Minimum opening pressure is 8.6 psi (.60 kg/cm2 )) |
||
| Thermostat R & I | THERMOSTAT | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | At normal operating temperature, oil pressure should be at least 4.3 psi (0.3 kg/cm2 ) or more at idle and approximately 43-85 psi (3.0-5.9 kg/cm2 ) at 3000 RPM. | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab | ||
| Flywheel/Flex Plate (Drive Plate) Torque | |||
| Flywheel/Drive Plate Bolt | Step 1) 36 Ft.lbs. (49 N.m) Step 2) Additional 90 Degree Turn |
||
| Fuel System | |||
| Pressure Specification | 38-44 psi (2.7-3.1 kg/cm2 ) | ||
| Fuel Pressure Test Procedure | LAND CRUISER & SEQUOIA | ||
| Fuel Filter Location | |||
| FUEL FILTER | |||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | NA | ||
| Spark Plugs | |||
| Type | NGK No. BKR6EYA DENSO No. K20R-U |
||
| Gap | .031 In. (.80 mm) | ||
| Torque | 13 Ft. Lbs. (18 N.m) | ||
| Starting | |||
| Starter | STARTER SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | SPECIFICATIONS | ||
| Torque | Refer to applicable components in PROCEDURES | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 83 Ft.lbs. (113 N.m) | ||