Charging System - Generators & Regulators: Generator: Replacement

1. Remove the 4 screws and bearing retainer. See Fig 1.
   Fig 1: Removing Bearing Retainer

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST and a press, press out the bearing. See Fig 2.

   SST 09950-60010 (09951-00260, 09952-06010)

   Fig 2: Identifying Bearing Removal SST

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using SST and a press, press in a new bearing. See Fig 3.

   SST 09950-60010 (09951-00520)

4. Install the bearing retainer with the 4 screws.

Torque: 3.0 N.m (31 kgf.cm, 27 in..lbf) 

Fig 3: Identifying Bearing Installation SST

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

CAUTION: Be careful not to damage the fan.
1. Using SST, remove the bearing cover (outside) and bearing. See Fig 4.

   SST 09820-00021

2. Remove the bearing cover (inside).
   Fig 4: Identifying Inside Outside Bearing Cover Removal SST

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Place the bearing cover (inside) on the rotor. See Fig 5.
   Fig 5: Identifying Bearing Cover

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Using SST and a press, press in a new bearing. See Fig 6.

   SST 09820-00031

   Fig 6: Identifying Bearing Installation SST

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Using SST, push in the bearing cover (outside). See Fig 7.

SST 09285-76010