Compressor And Magnetic Clutch: Installation
WARNING: This page is about a different car, the 2002 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
- Install compressor
:
- Install the compressor with cooler bracket with the 3 bolts and nut.
Torque:
Bolt: 47 N.m (480 kgf.cm, 35 in..lbf)
Nut: 25 N.m (255 kgf.cm, 18 in..lbf)
- Connect the connector.
- Install the compressor with cooler bracket with the 3 bolts and nut.
- Connect discharge and suction hoses
:
Connect the both hoses with the 2 nuts.
Torque: 10 N.m (100 kgf.cm, 7 in..lbf)
- Install and check drive belt . See DRIVE BELT and INSTALLATION .
- Connect negative (-) terminal cable to battery .
- Evacuate air from refrigeration system .
- Charge system with refrigerant
.
Specified amount :
Single A/C: 750 +/- 50g (26.45 +/- 1.76 oz.)
Dual A/C: 1050 +/- 50g (37.03 +/- 1.76 oz.)
- Inspect for leakage of refrigerant
:
Using a gas leak detector, check for leakage of refrigerant.
If there is leakage, check the tightening torque at the joints.
NOTE:
Hose should be connected immediately after the caps have been removed.
Lubricate 2 new O-rings with compressor oil and install them to the hoses.