Body Outside Moulding: Removal

NOTE: Do not heat moulding excessively.

Heat moulding :
Using a heat light, heat the moulding to 40 - 60°C (104 - 140°F).

CAUTION:

If reusing the moulding, take care not to damage the moulding.
Do not damage the body.

Remove moulding :
1. Tie both piano wire ends to a wooden block or a similar object.
2. Cut the adhesive tape by pulling the piano wire.
  
  Fig 1: Identifying Molding Removal Procedure
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the moulding.