LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2002 >> Camry XLE, 2.4 E >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Engine Immobilizer Systems >> Programming >> Registration Of Additional Sub-Key >> Using Toyota Hand-Held Tester

Using Toyota Hand-Held Tester

  1. Connect hand-held tester to data link connector No. 3. See Figure. When using hand-held tester, more detailed procedures may be displayed on tester while performing this procedure.
  2. Insert registered master key in ignition lock cylinder. Turn ignition on. Select SUB-KEY REGISTRATION on hand-held tester. Within 20 seconds, remove master key from ignition lock cylinder.
  3. Within 10 seconds of removing master key from ignition lock cylinder, insert sub-key to be registered in ignition lock cylinder. Ensure SECURITY indicator light flashes. SECURITY indicator light is located on A/C control panel.
  4. After one minute, additional sub-key should be registered and SECURITY indicator light should then turn off. The registration mode is complete after removing sub-key from ignition lock cylinder within 10 seconds and brake pedal is depressed, or SECURITY indicator light has turned off for at least 10 seconds.
scientia non olet · About LEMON Manuals