Deceleration Sensor Zero Point Calibration

NOTE: For description of Special Tools, see SPECIAL TOOLS .

1. Using Special Tool (09843-18040), connect terminals Ts and CG of DLC3. See Fig 1 and Fig 2 .
2. Turn ignition switch to ON position. Ensure vehicle is stationary with shift lever in Park.
3. Check that VSC warning indicator is lit for about 4 seconds, then starts quick blinking at .13 second intervals.
4. After confirming blinking of TRC OFF indicator light for 2 seconds, turn ignition switch to OFF position.
5. Remove special tool.

Fig 1: Identifying DLC3 Terminals Ts, Tc & CG

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 2: Locating DLC3 Connector

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002