Transaxle Specifications
TRANSAXLE SPECIFICATIONS
| Application | In. (mm) | ||
|---|---|---|---|
| Gear Radial Clearance (All) | |||
| Service Limit | .002 (.05) | ||
| Gear Thrust Clearances | |||
| 1st Gear | |||
| Service Limit | .016 (.40) | ||
| 2nd & 3rd Gear | |||
| Service Limit | .014 (.35) | ||
| 4th Gear | |||
| Service Limit | .022 (.55) | ||
| 5th Gear | |||
| Service Limit | .026 (.65) | ||
| Hub Sleeve-To-Shift Fork Clearance (Maximum) | |||
| 1st & 3rd Gear | .014 (.35) | ||
| 2nd Gear | .027 (.69) | ||
| Oil Pump Clearances | |||
| Housing-To-Drive Rotor | |||
| Standard | .004-.006 (.10-.16) | ||
| Service Limit | .012 (.30) | ||
| Drive-To-Driven Rotor Tip | |||
| Standard | .003-.006 (.08-.15) | ||
| Service Limit | .012 (.30) | ||
| Rotor-To-Housing (Side Clearance) | |||
| Standard | .001-.003 (.03-.08) | ||
| Service Limit | .006 (.15) | ||
| Pinion Gear Backlash | .002-.008 (.05-.20) | ||
| Reverse Idler Gear Bushing Inside Diameter | .7896-.7903 (20.056-20.074) | ||
| Reverse Idler Gear Shaft Outside Diameter | .7868-.7874 (19.984-20.000) | ||
| Synchronizer-To-Gear Clearance (Minimum) | |||
| 1st, 2nd & 5th | .028 (.70) | ||
| 3rd | .026 (.65) | ||
| 4th | .030 (.75) | ||
| 5th Gear Bushing Inside Diameter | 1.3772-1.3778 (34.981-34.997) | ||