Clearing Codes
CAUTION:
DO NOT disconnect vehicle battery to clear codes.
- To clear codes from cruise control ECU memory, locate DLC No. 1 in left side of engine compartment, near shock tower. Connect a jumper wire between terminals E1 and Tc at DLC No. 1. See Figure. Road test vehicle at 9 MPH or less. Holding cruise control switch in CANCEL position, depress cruise control ON-OFF (main) switch to ON position 5 times within 3 seconds.
- Fault codes are now erased from cruise control ECU memory. If problem has not been corrected or fault is still present, code will reset in cruise control ECU memory.
DIAGNOSTIC TROUBLE CODE (DTC) DEFINITIONS
| System Affected | Perform Test | ||
|---|---|---|---|
| Actuator Motor Circuit | 11 & 15 | ||
| Actuator Magnetic Clutch Circuit | 12 | ||
| Actuator Mechanical Fault | 14 | ||
| Vehicle Speed Sensor Circuit | 21 | ||
| VSS Signal Fault | 23 | ||
| Cruise Control Switch Circuit | 32 | ||
| Cruise Control ECU | (1) 41 | ||
| Power Source Voltage Drop | (1) 42 | ||
| Idle Signal Circuit | 51 | ||
|
|||