Taillight Relay
- Ensure ignition is off. Remove taillight relay. Taillight relay is located in instrument panel junction block and is marked as TAIL relay. See Figure.
- Note identification of electrical terminals on taillight relay. See Figure. Using ohmmeter, check that no continuity exists between terminals No. 3 and 5 on taillight relay. Check that continuity exists between terminals No. 1 and 2 on taillight relay.
- Using jumper wires, apply battery voltage and ground to terminals No. 1 and 2 on taillight relay. Check that continuity now exists between terminals No. 3 and 5 on taillight relay. See Figure. Replace taillight relay if defective.