Automatic Door Locking/Unlocking Function
The factory setting for the AUTOMATIC DOOR LOCKING/UNLOCKING FUNCTION is ON.
To change this feature's operation, follow the steps below:
- Sit in the driver's seat with the driver's door open.
- Insert the key into the ignition switch, and turn it to "ON" (not "ACC") 5 times (ON→LOCK→ON→LOCK→ON→LOCK→ON→LOCK→ON) within a 10 second period. The STATUS MONITOR'S LED turns on, and the PIEZO "CHIRPER" sounds once.
-YOU MUST PERFORM THE NEXT STEPS WITHIN 30 SECONDS-
- Select the operating mode.
PROGRAMMING PROCEDURE
| Mode | Programming Step | Programming Completion | |
|---|---|---|---|
| AUTOMATIC DOOR LOCKING & UN LOCKING ON | Close the driver's door. | => | Turn the ignition switch to the "LOCK"* position. (The PIEZO "CHIRPER" sounds once and the exterior lights flash once.) |
| AUTOMATIC DOOR LOCKING&UNLOCKING OFF | Close the driver's door, then open and close it one more time | => | Turn the ignition switch to the "LOCK"* position. (The PIEZO "CHIRPER" sounds n/twice, and the exterior lights flash twice.) |
* If you fail to turn the ignition key to "LOCK" or exceed 30 seconds during the programming steps, the STATUS MONITOR'S LED will turn off, and the previous operation mode will remain unchanged.