LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2000 >> Sienna LE >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Self-Diagnostics >> Diagnostic Tests >> DTC P0500: Vehicle Speed Sensor Circuit >> Diagnosis & Repair

Diagnosis & Repair

  1. Test drive vehicle and check operation of speedometer. If speedometer is not operating correctly, repair speedometer as necessary. See appropriate INSTRUMENT PANELS article in ACCESSORIES & EQUIPMENT. If speedometer is operating correctly, go to next step.
  2. Access ECM behind glove box. Ensure ignition is off. Disconnect ECM harness connector E9. Check continuity between ground and terminal No. 22 (Violet/Yellow wire) at ECM harness connector E9. See Figure. If continuity exists, locate and repair short to ground. If continuity does not exist, go to next step.
  3. Turn ignition on. Measure voltage between ground and terminal No. 22 (Violet/Yellow wire) at ECM harness connector E12. If voltage is 9-14 volts, replace ECM. If voltage is not 9-14 volts, repair open in wiring between instrument cluster and ECM. See WIRING DIAGRAMS article.
scientia non olet · About LEMON Manuals