Ignition Switch

Disconnect connector from ignition switch on steering column. Note ignition switch terminal identification and ignition lock cylinder positions. See Fig 1.

Using ohmmeter, check that continuity is as specified between indicated ignition switch terminals in relation to ignition lock cylinder position. See IGNITION SWITCH CONTINUITY table. Replace ignition switch if defective.

IGNITION SWITCH CONTINUITY

Lock Cylinder Position

Ignition Switch Terminal No.

Specification

LOCK

⁽¹⁾

ACC

1 & 3

Continuity

ACC

1, 2, & 3; 5 & 6

Continuity

START

1 & 2; 4, 5 & 6

Continuity

⁽¹⁾	There should be no continuity between any terminals.

Fig 1: Ignition Switch Terminals & Ignition Lock Cylinder Positions