Abs Actuator
- Using fused jumper wires, connect terminals Tc, Ts and E1 together at Data Link Connector 1 (DLC1), located in engine compartment. See Fig 1.
- Turn ignition on. ABS warning light should flash once every 1.5 seconds to indicate air bleed mode. Depress brake pedal one time and hold. After one second, pressure reduction solenoid should operate for 0.5 seconds, and brake pedal will reach end of it's travel.
- Release brake pedal. After 0.5 seconds, ensure pump motor operates for 1.5 seconds. DO NOT depress brake pedal while pump motor is operating. Observe ABS warning light. If ABS warning light flashes once every second, turn ignition off. Bleed brakelines. See BRAKELINES . Go to next step. If ABS warning light flashes once every 2 seconds, repeat bleeding procedure beginning with step 1.
- Repeat steps 1- 3
several times. Repeat procedure for each wheel until air bubbles are no longer present. Remove jumper wires from DLC1. Ensure brake fluid reservoir is full.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002