LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2000 >> Corolla LE, Automatic >> Repair and Diagnosis >> Body & Frame >> Power Windows >> Component Tests >> Driver's Power Window Motor Circuit Breaker Test >> Corolla

Driver's Power Window Motor Circuit Breaker Test: Corolla

  1. Slightly lower driver's window. Disconnect 14-pin harness connector from driver's power window master switch. Connect jumper wire from positive terminal of 12-volt battery to terminal No. 5 (Green wire) at master switch connector (harness side). See Figure. Connect another jumper wire from negative terminal of battery to terminal No. 1 (Yellow wire) at master switch connector (harness side). Window should raise to fully closed position. If window operates correctly, go to next step. If window does not operate correctly, go to POWER WINDOW MOTOR TEST .
  2. Continue to apply voltage until there is an audible click from power window motor circuit breaker (within 4-40 seconds). Reverse polarity and ensure window begins to descend within about 60 seconds. If operation is not as specified, replace power window motor. See POWER WINDOW MOTOR  under REMOVAL & INSTALLATION. If operation is as specified, power window motor circuit breaker is okay.
scientia non olet · About LEMON Manuals