Brake Booster Push Rod
- Install adjusting gauge on master cylinder with master cylinder gasket in place. Lower adjusting gauge pin until pin slightly touches master cylinder piston. See STEP 1. See Fig 1 and Fig 2
. Turn adjusting gauge upside-down and install on power brake booster.
- Measure clearance between brake booster push rod and adjusting gauge pin head. See STEP 2. See Fig 1 and Fig 2
. Measured clearance should be zero. If clearance is not zero, adjust brake booster push rod length until push rod lightly touches adjusting gauge pin head.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002