2-Door Models
- Connect 3 "D" cell batteries in series, creating 4.5 volts. Connect VGS terminal of deceleration sensor to positive (+) side of batteries. See Fig 1. Connect GND terminal to negative (-) side of batteries.
- Measure voltage between terminal GL1 and ground, and between terminal GL2 and ground at deceleration sensor. Ensure sensor is within specifications. See DECELERATION SENSOR SPECIFICATIONS table. If sensor is not within specification, replace sensor. A deceleration sensor malfunction will cause ABS warning light to flash DTC 79.
DECELERATION SENSOR SPECIFICATIONS
| Terminal |
Position |
Voltage |
| GL1 |
Horizontal |
2.3 |
| GL1 |
Leaning Front |
0-2.3 |
| GL1 |
Leaning Rear |
2.3-4.5 |
| GL2 |
Horizontal |
2.3 |
| GL2 |
Leaning Front |
2.3-4.5 |
| GL2 |
Leaning Rear |
0-2.3 |
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002