Door Unlock Detection Switch

Remove door trim and door lock assembly. Locate and disconnect door unlock detection switch connector. Check for continuity between connector terminals No. 1 (left front is Pink/Blue wire, right front is Pink wire, and left or right rear is Yellow wire) and No. 2 (left or right front is White/Black wire) or No. 3 (left or right rear is White/Black wire). There should be continuity when door lock is in unlocked position. There should be no continuity when door lock is in locked position. If continuity is not as specified replace door unlock detection switch. If continuity is as specified, inspect harness and connectors between door unlock detection switch and ATS ECU. See PIN VOLTAGE TESTS .