Test 2: Door Unlock Detection Switch Circuit

With ignition switch in OFF position, remove wireless door lock ECU from below radio. See Figure. Place all door lock knobs in lock position (door unlock detection switch off). For left front door, measure voltage between ground and ECU connector terminal No. 11 (Blue/Red wire). For right front door, measure voltage between ground and ECU connector terminal No. 12 (Yellow wire). For rear doors, measure voltage between ground and ECU connector terminal No. 13 (Blue/Yellow wire). See Figure. Battery voltage should exist at each individual voltage reading. If battery voltage does not exist, repair appropriate circuit. If battery voltage exists, proceed to next test given in TROUBLE SHOOTING SYMPTOMS  table.