Air Induction System: Supercharger: Installation

To install, reverse removal procedure using NEW gaskets. Tighten bolts/nuts to specifications. See TORQUE SPECIFICATIONS table. Install and adjust drive belts to specification. See DRIVE BELT ADJUSTMENT SPECIFICATIONS table.

DRIVE BELT ADJUSTMENT SPECIFICATIONS Tension In Lbs. (kg) Using Burroughs Tension Gauge

Application

New Belt

⁽¹⁾ Used Belt

A/C

165 (75)

130 (59)

Generator

170 (77)

125 (57)

Power Steering

180 (82)

135 (61)

Supercharger

170 (77)

125 (57)

⁽¹⁾	Used belt is a belt in operation at least 5 minutes.

Fill cooling system. Fill supercharger with 4.4 Ozs. (.13L) of Supercharger Oil (Part No. 08885-80108) if oil was drained.
If supercharger oil was not drained, check supercharger fluid level with engine cold and vehicle on level surface by using Yellow-colored dipstick on supercharger.
Ensure dipstick is fully screwed into supercharger when checking oil level. Oil level should be at full mark on oil dipstick. Add Supercharger Oil (Part No. 08885-80108) if necessary. DO NOT overfill supercharger or supercharger may be damaged.