Ignition Switch Continuity Test: 1995

Disconnect negative battery cable. Removedriver's lower instrument panel cover. Remove upper and lower steering column covers if needed. Locate ignition switch wiring harness 8-pin connector. See Fig 1-Fig 2 .
With ignition switch in LOCK position, there should be no continuity between any terminals. With ignition switch in ACC position, there should be continuity between terminals No. 2 and 3. With ignition switch in ON position, there should be continuity between terminals No. 1, 2 and 3, and between terminals No. 7 and 8.
With ignition switch in START position, there should be continuity between terminals No. 1, 4 and 6, and between terminals No. 7 and 8. If continuity is not as specified, replace switch.

Fig 1: Identifying Ignition Switch 8-Pin Connector (1995)

Fig 2: Identifying Ignition Switch 8-Pin Connector (1996)