LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1995 >> T100 Base >> Repair and Diagnosis >> Electrical >> Starter >> Starting System >> On-Vehicle Testing >> Clutch Start Cancel Switch Test

Clutch Start Cancel Switch Test

  1. Locate switch in left dash panel. Remove right lower instrument panel to access switch connector. Disconnect wiring harness connector from switch pigtail connector. See Fig 1.
  2. Connect negative lead of ohmmeter to terminal No. 1. Ensure continuity does not exist between connector terminals No. 1 and 2, terminals No. 1 and 3, and terminals No. 2 and 3. Check operation of switch by connecting jumper wires from 12-volt battery. Connect positive lead to terminal No. 3 and negative battery lead to terminal No. 1.
  3. Using ohmmeter, ensure continuity does not exist between connector terminals No. 1 and 2 until switch button is pushed. When switch button is pushed, switch light should come on and continuity should exist. Disconnect battery and ensure continuity does not exit between terminals No. 1 and 2. If switch does not test as specified, replace switch.
Fig 1: Identifying Clutch Start Cancel Switch Connector Terminals
G93F02153Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals