LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1994 >> Previa DX, RWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft System >> Testing Anti-Theft Circuits >> Testing Anti-Theft System Components >> Slide Door Junction

Slide Door Junction

Open slide door and locate 2-pin junction "A" and below it, 3-pin junction "B" at door edge. Connect ohmmeter positive lead to junction "A" and negative lead to junction "B". Within both junctions, terminal No. 1 is on top. Insert key into lock and turn and hold in LOCK position (clockwise). Ensure no continuity exists between terminals A1-B1, A2-B2, A1-B3, and A2-B1. Ensure continuity exists between terminals A2-B2 and A2-B3. Turn key to UNLOCK position (counterclockwise) and hold. Ensure continuity exists between terminals A1-B1, A1-B2 and A1-B3. Ensure no continuity exists between terminals A2-B1, A2-B2 and A2-B3.

Reverse ohmmeter leads, negative lead to junction "A" and positive lead to junction "B". Ensure no continuity exists between terminals A1-B1, A1-B2, A1-B3, A2-B1, A2-B2 and A2-B3 with key held in LOCK position. With key held in UNLOCK position, ensure continuity exists between A1-B1 and no continuity exists between A1-B2, A1-B3, A2-B1, A2-B2 and A2-B3. If continuity is not as specified, replace junction(s) and retest.

NOTE: For other anti-theft or door lock components, see the DOOR LOCKS - POWER article in the ACCESSORIES/SAFETY EQUIPMENT section.
scientia non olet · About LEMON Manuals