Park/Neutral Switch Continuity Check
Disconnect electrical connector from park/neutral switch at transmission or transaxle. Using ohmmeter, check for continuity at specified terminals with gearshift in proper positions. See Fig 1. See PARK/NEUTRAL SWITCH CONTINUITY table. Replace switch if defective.
PARK/NEUTRAL SWITCH CONTINUITY
| Gearshift Position | Check Between Terminals |
|---|---|
| Park | 5 & 6, 4 & 7 |
| Reverse | 4 & 8 |
| Neutral | 5 & 6, 4 & 10 |
| Drive | 4 & 9 |
| 2 | 4 & 2 |
| Low | 4 & 3 |