Ignition Switch Continuity Test
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- Disconnect negative battery cable. Remove driver's lower instrument panel cover. Remove upper and lower steering column covers if needed. Locate ignition switch wiring harness 10-pin connector. See Fig 2.
- With ignition switch in LOCK position, there should be no continuity between any terminals. With ignition switch in ACC position, there should be continuity between terminals No. 3 and 4. With ignition switch in ON position, there should be continuity between terminals No. 2, 3 and 4, and between terminals No. 9 and 10. With ignition switch in START position, there should be continuity between terminals No. 2, 4 and 7, and between terminals No. 6, 9 and 10. If continuity is not as specified, replace switch.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002