Throttle Position Sensor Adjustment

Disconnect electrical connector from Throttle Position Sensor (TPS). Loosen mounting screws. Connect ohmmeter between terminals IDL and E1 (MR2 2.2L with M/T) or E2 (all others). See Fig 1 & 9.
Apply vacuum to throttle opener (if equipped). See Fig 1 & 9. To set initial clearance, insert proper thickness feeler gauge between throttle stop screw and throttle lever. See V6 THROTTLE POSITION SENSOR ADJUSTMENT table.
With ohmmeter showing no continuity, rotate TPS clockwise until continuity exists. Tighten mounting screws. Using specified feeler gauge, recheck adjusted clearance. Disconnect ohmmeter and install electrical connector on TPS.

V6 THROTTLE POSITION SENSOR ADJUSTMENT

Model

Clearance In. (mm)

Initial Clearance In. (mm)

Ohms

Camry ⁽¹⁾

.021 (.53)

.014 (.36)

Continuity

.028 (.71)

No Continuity

Pickup & 4Runner

.024 (.61)

.020 (.51)

Continuity

.030 (.76)

No Continuity

⁽¹⁾	Apply vacuum to throttle opener before checking TPS adjustment.

Fig 1: Adjusting Throttle Position Sensor (Camry)

Fig 2: Adjusting Throttle Position Sensor (P/U & 4Runner)

Fig 3: Typical Idle Speed Adjusting Screw Locations Id