LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1990 >> Pickup Base, 22R >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock >> Bleeding >> Manual Bleeding

Manual Bleeding

  1. Exhaust vacuum from power unit by depressing brake pedal several times.
  2. Fill master cylinder. Install a clear vinyl bleeder hose onto first bleeder valve to be serviced. See BLEEDING SEQUENCE . Place other end of hose in clean transparent container.
  3. Partially fill container with clean brake fluid so end of hose is submerged in fluid. Open bleeder valve 1-2 turns. Slowly depress brake pedal through its full travel.
  4. Close bleeder valve and release pedal. Pump pedal several times and push air toward wheel cylinders. Repeat procedure until flow of brake fluid is clear and shows no sign of air bubbles. Proceed to next bleeder valve.
NOTE: Check fluid level in master cylinder frequently during bleeding sequence.
scientia non olet · About LEMON Manuals