Feed To Ignitor Test
WARNING: This page is about a different car, the 1989 Toyota Supra, 1989 Toyota Land Cruiser, and 1989 Toyota Cressida. However, it is still accessible from the selected car via links, so may be relevant.
Turn ignition off. Unplug ignition module 6-pin connector. Ignition module 6-pin module connector is located next to alternator. Turn ignition switch to the "ON" position. Check for 12 volts between terminal No. 3 and ground. See Fig 1. Reconnect 6-pin connector. If feed voltage is not present, repair open in wiring harness and retest system. If feed circuit is okay, proceed to PICK-UP COIL RESISTANCE.